Rate the Wire Management Above You!

Front panel - Always intake.
Side panel - Usually intake.
Bottom panel - Intakes again.
Rear panel - Always exhaust.
Top Panel - Always exhaust.

IMO.

I'll second that...some rare builds I've changed it a bit due to where the comp was being stored but that's the general guideline I follow.
 
Here is mine:

img2870lq4.jpg


Wiring is tricky in this case. Since I have the bay with the power switch etc right at the top, the grey USB cables *only just* reach, so I can't take them underneath, to come out from behind the tray beneath the board.

I can't see anywhere to route the SATA cables either.

But yea, thought I'd post it up anyway :p
 
Back
Top Bottom