[Project] Prototype

[Prototype]

72F you mean? I doubt you would be alive if it were 72C outside

Lol yeah. Now I idle at 40C. Is there a program to control the fan speed or will I just need to connect the fan to the power supply to run full speed because only 2 of them are just running at 600 RPM and the others show 0 RPM. Running 3dmark06 at stock with 1 GPU right now. Will post results and temperatures after then will go back and fix some wires.

EDIT:
3DMark06
Lowest temperature: 40C
Highest temperature: 55C
Score: 18,640

 

[Burn]

Ah, that score is loads better. Start OCing and see what two of them can do.

 

[Prototype]

Man are you sure crossfire is enabled? That score seems way to low. Check out GPU-Z and see what it says.

Let me put the second card in and run 3dmark at stock and overclocked.

 

[Burn]

^Lol when I wrote that I didn't see that you said only 1 GPU. my bad

 

[Prototype]

Ran 3dmark06 and gave me 18627. Checked GPU-Z and says Disabled(Crossfire Available). Now I gotta run another 8 min test.

EDIT:
(Posting scores in here)

Crossfire Stock
Score:

Crossfire & Overclock 3.2GHz
Score:

 

[Prototype]

Ok. I am going to start overclocking right now. Last week, my OS went corrupt and took me 7 hours to fix the problem. I scored a 28900 with 4.2GHz and 5870 Crossfire maxed out. Now going for 30k will post results in 20 minutes. I wish CCC would let me overclock my 5870s higher, there is a lot of room for overclocking.

 

[yzmxer608]

Have you tried Rivatuner?

 

[Burn]

Ya CCC sucks... Use rivatuner

 

[yzmxer608]

Wonder how the adjustable voltage is going to work out, is that something that you can only change through the ATI software so far?

 

[Burn]

I use GPUTool to adjust my voltage. Dunno if it will work for 5870's though.