Overclocking X800

[fury36]

Im using ATITool 0.24 to overclock my X800, but im not quite sure what the best stable settings would be. (for the Core & Memory)

Heres a link to my card: http://www.overclockers.co.uk/acatalog/X800_Series.html (the top one)

 

[Sh0r_ty]

all cards are differant so all u can really do is raise them slowly and check for artifacts. for me its stable it u can run 5 loops of 3dmark05 arti free and play quake/doom/fear

5mhz is usually a good amount to rais it buy each time and then run a small artifact test (mabe the ati tool one) and then ever 30mhz or so do a full test with a couple of 05 runs

then when u have it at what it seems best at u should do a complete test

 

[bkolk]

5mhz is usually a good amount to rais it buy each time and then run a small artifact test (mabe the ati tool one) and then ever 30mhz or so do a full test with a couple of 05 runs

Do you raise both memory and core clock at the same rate together?

 

[FghtinIrshNvrDi]

Raise them seperately, finding out what the maximum is for both. For instance, on my X700, I did this...

Went into my program. Stock settings were 400/500.
1. Creep up the core clock by 5-6mhz until I got an artifact. I top out at 489ish. Then I back it off to 475 for safety reasons.
2. Creep up the memory by 5-6mhz until I got instability. I top at at a meager 526. I backed it off to 518 for safety reasons.

Ryan