MKmods.. Case Gallery

Status
Not open for further replies.
Honestly unless you have a very through knowledge working with electricity in this litigious world we live in its better not to mess around.

What I do is figure every device I am going to use, I remove all the wires from the PS and only use wires I need, I replace several small ones with a bigger one.

I clean up their mess and make the PS more efficient. Usually I can reduce 50 to 60% of the wiring.
 
easy never enters into my consideration, better, smaller more efficient,cooler does.

If I was making mass market cases/comps than easy would be important.

I posted another pict of my SFF red comp with it open. There is absolutely no room for a whole PS inside it.
 
it could be, but not as much fun :D

and i thought thats what you meant, but wasn't 100% sure. and thats a good idea, but I'm going to go ahead and assume you don't have spare wires, so you won't be able to add anything more to the system without messing up your wiring job.
 
Thanks Aspire.
I get the carbon fiber material at TapPlastics.com (careful its not cheap)

If you search Carbonfiber on YouTube there are a bunch of tutorials.
 
Status
Not open for further replies.
Back
Top Bottom