veedubfreak
Golden Master
- Messages
- 6,979
Ok so i got bored. Yanked out the TRUE and the q6600 and a framed picture off the wall. Taped the sand paper down, and started sanding. Only used 400grit, didnt go for mirror finish, just wanted to get rid of the nickel plating and get it flatter. I seem to have gotten cores 1 2 3 closer in temps, but core 0 still wants to run close to 10C hotter than everything else. According to my razor blade everything is flat, but i think i might have to penny mod my TRUE because i dont think its pressing down on the CPU hard enough. Current temps at 3.6ghz are 27/19/20/24 with room temp at 65F. Temps did seem to come down across the board though by a few degrees. Will report back once the as5 has time to set up again.