Lol on the tubing behind the motherboard, would have been a snug fit
After looking closely i realized this case has mounting holes for the mcp35X which is great, so since the tubing is not really an issue I'll just mount it at the bottom. How this loop look? I think it works better having the Rad ports at the backside of the case personally.
Doesn't really look like too much tubing, just a couple of awkward bends, Ill have to make sure I utilize some good bitspower fittings I guess.
On another note I was going to use 3/8x1/2 tubing as I think this is most common, I'm aware this doesn't really make much difference, is that what you normally use?