Cant post at lower divider

[cliffhucker]

Not sure what my sig says but I am 275x10

And stable at 5:6 (333) ~230MHz

But I am not stable when encoding. So I want to declock my ram.

I am fine with a 1:2 (200) divider and can post but cannot post with a 2:3 (266) divider no matter what my timings and voltage is???


Any ideas why I cannot reach this middle ground?

I have run this proc. speed at that divider before. Could the ram be damaged at that divider? since the last time a I crashed trying 280 I was at the 2:3 divider.

Thanks for any input.

 

[reggie_da_man]

Your ram is probably at too high a speed for it to work.