HI all. I am having a bit of trouble getting even stock RAM speed on my OC. Here are my system specs:
AMD64 3000+ Venice
MSI K8N neo2 plat, BIOS v1.8 (wish I would have gotten the DFI ><)
OCZ EL PC3200
eVGA 6800gt
Seagate 160Gig SATA (in SATA port 3)
80 GIG IDE
Right now my OC is at CPU 2430GHZ/ Ram 180Mhz on a 133 divider (1T, stock timing)
High Performance Mode......Manual
Aggressive Timing.............Disabled
Dynamic O/C....................Disabled
Spread Spectrum.............Disabled
HT Frequency..................3x
Cool 'n Quiet....................Disabled
Adjust CPU Ratio...............9x
Adjust CPU FSB Freq.........270
Adjust AGP Freq...............66
Adjust CPU VID................1.500
CPU Voltage....................by VID
Mem Voltage....................2.70v
I can get my CPU up to 2.7 no prob on a 100 divider (Ram = 150mhz on 9x, 300 HTT, 100 divider / 1T ).
on a 1:1 divider i was able to get the ram up to 216mhz after that it would not POST any more. BUT wen i use a divider other then 1:1 (200 mhz or auto) to get higher CPU clocks it wont reach even 200mhz tops out at bout 180mhz
I Have tried to up the mem volts and loosen timings but still canÂ’t get past 270 HTT (Ram = 180Mhz) on the above settings.
Also tried: 8x multiplier, 300 HTT, 133 divider and still no luck
I am still very new to OCing any help would be appreciated. Thanx
AMD64 3000+ Venice
MSI K8N neo2 plat, BIOS v1.8 (wish I would have gotten the DFI ><)
OCZ EL PC3200
eVGA 6800gt
Seagate 160Gig SATA (in SATA port 3)
80 GIG IDE
Right now my OC is at CPU 2430GHZ/ Ram 180Mhz on a 133 divider (1T, stock timing)
High Performance Mode......Manual
Aggressive Timing.............Disabled
Dynamic O/C....................Disabled
Spread Spectrum.............Disabled
HT Frequency..................3x
Cool 'n Quiet....................Disabled
Adjust CPU Ratio...............9x
Adjust CPU FSB Freq.........270
Adjust AGP Freq...............66
Adjust CPU VID................1.500
CPU Voltage....................by VID
Mem Voltage....................2.70v
I can get my CPU up to 2.7 no prob on a 100 divider (Ram = 150mhz on 9x, 300 HTT, 100 divider / 1T ).
on a 1:1 divider i was able to get the ram up to 216mhz after that it would not POST any more. BUT wen i use a divider other then 1:1 (200 mhz or auto) to get higher CPU clocks it wont reach even 200mhz tops out at bout 180mhz
I Have tried to up the mem volts and loosen timings but still canÂ’t get past 270 HTT (Ram = 180Mhz) on the above settings.
Also tried: 8x multiplier, 300 HTT, 133 divider and still no luck
I am still very new to OCing any help would be appreciated. Thanx
