overlord20
Fully Optimized
- Messages
- 2,308
- Location
- spokomptan
My case is a generic mid tower. I managed to do some decent cable management and it is still really hot. To fit the stuff in the case I had to remove the side 90mm exhaust fan.
I stuck the 90 i had to remove up front. Now I have 2 90mm intakes in the front and 1 120mm in the back. I am going to put a 120 mm fan on the top of the case and want to know if I should point it in or out.
Right now this is how the air flows.
Pushed in with 2 90mm front fans. Pushed through Xigmateck Dark Night with 120mm fan and then out of the case with a rear 120mm fan.
Ambient temp aren't always the best so i was going to add 1 120mm to the top using parts from MNPCTECH.
I stuck the 90 i had to remove up front. Now I have 2 90mm intakes in the front and 1 120mm in the back. I am going to put a 120 mm fan on the top of the case and want to know if I should point it in or out.
Right now this is how the air flows.
Pushed in with 2 90mm front fans. Pushed through Xigmateck Dark Night with 120mm fan and then out of the case with a rear 120mm fan.
Ambient temp aren't always the best so i was going to add 1 120mm to the top using parts from MNPCTECH.