spikoman69
Daemon Poster
- Messages
- 726
Ok, the only difference between what i currently have and a normal ATX p 20 pin is pin 18, normally on the atx its white, and on mine, well theres not even a wire going into there, dell.com says that there shouldnt be one there, so if there all the same, should i just snip the white wire in some spot, and just electrical tape the end to prevent electricty from getting out, or what would be the best way?
Also, what do you mean by SHIELD your psu wires?
Also, what do you mean by SHIELD your psu wires?