Well, I haven't been doing this as long as some of you...lemme know what you think about this fan setup.
Currently I have:
Intake-
2x80mm left-panel
1x80mm front-bezel
Exhaust-
1x120mm rear
1x80mm blowhole
2x80mm PSU (but only one spins unless it gets too hot)
Later today, after everybody is awake, I'm going to bust out the Dremel and whack a hole in the right-side panel, and I'm thinking about having an 80mm exhaust, that should draw heat off the harddrives.
Rather than endlessly changing fan configurations (considering most fans are tied in with a million wires) I figured I'd ask here.
Currently I have:
Intake-
2x80mm left-panel
1x80mm front-bezel
Exhaust-
1x120mm rear
1x80mm blowhole
2x80mm PSU (but only one spins unless it gets too hot)
Later today, after everybody is awake, I'm going to bust out the Dremel and whack a hole in the right-side panel, and I'm thinking about having an 80mm exhaust, that should draw heat off the harddrives.
Rather than endlessly changing fan configurations (considering most fans are tied in with a million wires) I figured I'd ask here.