sPlAtOiD
Fully Optimized
- Messages
- 1,748
HI I'm having a little problem. I got a used Chaintech VNF3-250.
Its works great the manual that came with it sucks. And after screwing around with it for 5 hours trying to set up my raid configuration I Finley got it up and running but instead of striped raid array its 2 separate serial ATA drives. Now I can live with that but then I'm trying to install 2 300 gig hard drives that are just storage no OS on either of them. Well when I plug the first one in to my IDE Slot either primary or secondary slot the computer wont find the operating system and tries to boot from CD ROM. Ive even disabled the CD Roms and switched the settings in bios around with no luck. Anybody know what the **** I'm doing wrong.
Also with this motherboard when I put 3 sticks of 512 identical ram It wont boot its says something about memory timing. Other than that it runs great with only 1 gig of ram. Sorry this is so wordy but its driving me nuts.
And is it normal for a 3200+ 64 bit chip to run at just 7.0 to 9.0 C.
Its works great the manual that came with it sucks. And after screwing around with it for 5 hours trying to set up my raid configuration I Finley got it up and running but instead of striped raid array its 2 separate serial ATA drives. Now I can live with that but then I'm trying to install 2 300 gig hard drives that are just storage no OS on either of them. Well when I plug the first one in to my IDE Slot either primary or secondary slot the computer wont find the operating system and tries to boot from CD ROM. Ive even disabled the CD Roms and switched the settings in bios around with no luck. Anybody know what the **** I'm doing wrong.
Also with this motherboard when I put 3 sticks of 512 identical ram It wont boot its says something about memory timing. Other than that it runs great with only 1 gig of ram. Sorry this is so wordy but its driving me nuts.
And is it normal for a 3200+ 64 bit chip to run at just 7.0 to 9.0 C.