Hey guys, this is my first post, I've been reading the boards for quite some time now, but this was the first time I ever needed to post a question.
I saw a similar topic, but it seemed a little different, so I didn't wanna hijack anyone elses thread on them.
Basically I was on my computer, and it just turned off, and I haven't been able to get it to turn back on. I opened up the case and checked all of my connections, but haven't had any luck. Basically, when I push the power button, nothing happens except if you look very closely at 1 of my LED fans, you might notice a quick "flicker" of light, that keeps happening once every minute or so. Also, the POST display is lit up, reading 00 until the power is pushed, then alternating from 8.3. to 9.6. once the power is pushed. Referirng to the manual, 8.3. means "ATX power supply ready" and 9.6. mean "De-assert CPU core voltage". Not sure exactly what all of that means.
Another things I should probably mention is that the only over clocking that I ever did was for my graphics card using PowerStrip, and the computer shut down while I was running a 3dmark06 test.
I included some specs under my sig.
Do you guys have any clue what could be wrong, I was thinking either the power supply or the motherboard, but I dont have another power supply to swap at the moment to test it.
Thanks in advance, any insight would be helpful.
I saw a similar topic, but it seemed a little different, so I didn't wanna hijack anyone elses thread on them.
Basically I was on my computer, and it just turned off, and I haven't been able to get it to turn back on. I opened up the case and checked all of my connections, but haven't had any luck. Basically, when I push the power button, nothing happens except if you look very closely at 1 of my LED fans, you might notice a quick "flicker" of light, that keeps happening once every minute or so. Also, the POST display is lit up, reading 00 until the power is pushed, then alternating from 8.3. to 9.6. once the power is pushed. Referirng to the manual, 8.3. means "ATX power supply ready" and 9.6. mean "De-assert CPU core voltage". Not sure exactly what all of that means.
Another things I should probably mention is that the only over clocking that I ever did was for my graphics card using PowerStrip, and the computer shut down while I was running a 3dmark06 test.
I included some specs under my sig.
Do you guys have any clue what could be wrong, I was thinking either the power supply or the motherboard, but I dont have another power supply to swap at the moment to test it.
Thanks in advance, any insight would be helpful.