alexsabree
Fully Optimized
- Messages
- 1,845
- Location
- United States
Basically i have this in my build
6800gs
pentium 4 @ 3.5
2x256 value ram (going to be 4x256 value ram soon)
Xfi Music Edition
Hard Drives:
80gb SATA
80gb ATA
Cd Burner/player (ATA)
I have had lots a problems.
Ok first... everything was fine.. everything was hooked up and then all the sudden it stops working.. right after i try to put in an old DVD player.
First it showed only the C: Drive (80gb Sata) + D: Drive (Cd Player)
I tryed to make the E drive get recognised... then when i started switching them around, only the C drive was recognised. no cdplayer
QUESTIONS!!!
I know the jumpers on the back are wat show slave and master... but which is which? (on the cord)
There is a jumper that says soemthing about Sata and ata compatability.. should i put them in that formation?
If u had any guesses as to wat could b wrong, it would b really appreciated
6800gs
pentium 4 @ 3.5
2x256 value ram (going to be 4x256 value ram soon)
Xfi Music Edition
Hard Drives:
80gb SATA
80gb ATA
Cd Burner/player (ATA)
I have had lots a problems.
Ok first... everything was fine.. everything was hooked up and then all the sudden it stops working.. right after i try to put in an old DVD player.
First it showed only the C: Drive (80gb Sata) + D: Drive (Cd Player)
I tryed to make the E drive get recognised... then when i started switching them around, only the C drive was recognised. no cdplayer
QUESTIONS!!!
I know the jumpers on the back are wat show slave and master... but which is which? (on the cord)
There is a jumper that says soemthing about Sata and ata compatability.. should i put them in that formation?
If u had any guesses as to wat could b wrong, it would b really appreciated