I have an Asus K8V SE Deluxe Motherboard with a Seagate ST3200822A 200GB ATA and a Maxtor 6Y080L0 80GB ATA hard drive, and I removed them both to put into another system to pop some large files off, and now when I put both drives on the Primary IDE connector, the Seagate is detected (Master) and the Maxtor is not seen, but if you remove the Seagate, the maxtor is detected fine!
I cannot understand why its doing this, as I have tried them BOTH in a different computer and both work happily alongside eachother, which indicates they both work, and theres a fault with my IDE controller, but the same happens on the secondary IDE port, although if on different connectors they work! I am now stumped as what to do! Any help would be appreciated
Thanks in advance
Ruan
I cannot understand why its doing this, as I have tried them BOTH in a different computer and both work happily alongside eachother, which indicates they both work, and theres a fault with my IDE controller, but the same happens on the secondary IDE port, although if on different connectors they work! I am now stumped as what to do! Any help would be appreciated
Thanks in advance
Ruan