I purchased a motherboard to fix an old computer. I tried to install a pentium 3 coppermine 600 but no response
(hard drive spins, no beep, fans power)
it did work with one of 4 p3 katmai 500s but required a bios update in order to pass the bios setup
I created a bootable disk with an ibm program which autmoatically executed in the bios setup because of an ibm software (update to v31a)
the flash program loaded but gave me a error "Not enough memory"
there is 256mb pc100 (i think) installed, 20gb hd, radeon 7500 agp
there are two switchboard labeled sw1 and sw2, the first with 4 and the second with 8 switches, all set to off
it is a slot 1 motherboard (possibly micro atx) FRU 61H22470
can anyone help get the coppermine to work with the motherboard?
or at least the bios update to work?
Thanks!
David
(hard drive spins, no beep, fans power)
it did work with one of 4 p3 katmai 500s but required a bios update in order to pass the bios setup
I created a bootable disk with an ibm program which autmoatically executed in the bios setup because of an ibm software (update to v31a)
the flash program loaded but gave me a error "Not enough memory"
there is 256mb pc100 (i think) installed, 20gb hd, radeon 7500 agp
there are two switchboard labeled sw1 and sw2, the first with 4 and the second with 8 switches, all set to off
it is a slot 1 motherboard (possibly micro atx) FRU 61H22470
can anyone help get the coppermine to work with the motherboard?
or at least the bios update to work?
Thanks!
David
