I bought a Soyo KT600 Dragon Plus with Phoenix D686 BIOS to replace a suspected blown motherboard.
I have an AMD Duron 900Mhz processor. The dipswitches for the multiplier are all off, which may or may not be relevant because I haven't done anything to the processor, so I assume that it is not unlocked. (I'm a software guy, not a hardware guy). Can someone tell me for sure?
I have two memory sticks: Kingston ValueRAM 256 and Centon 512 MB
The FSB jumpers are set for 200 MHz - Is that right?
I removed all devices from the board: hard drive, CD ROM, floppy, RAM. I left the video card ( new Mad Dog Predator MX 4000)installed and put the board on a piece of cardboard with
There are 2 big problems (so far):
1. As soon as I plugthe power cord into the power supply, the Anti-Burn Regulator Alarm goes off. I have removed the jumper to disable it but it didn't make a difference still goes off.
2. When I power up, the ABR alarm stops, the fans all come on but there is no post. There are no beeps from the speaker and nothing is displayed on the monitor.
I have cleared the CMOS a number of times without success.
I'm assuming that my processor is fried. Maybe I zapped it during the installation process or it got fried when the other motherboard fried.
Any thoughts?
Thanks
I have an AMD Duron 900Mhz processor. The dipswitches for the multiplier are all off, which may or may not be relevant because I haven't done anything to the processor, so I assume that it is not unlocked. (I'm a software guy, not a hardware guy). Can someone tell me for sure?
I have two memory sticks: Kingston ValueRAM 256 and Centon 512 MB
The FSB jumpers are set for 200 MHz - Is that right?
I removed all devices from the board: hard drive, CD ROM, floppy, RAM. I left the video card ( new Mad Dog Predator MX 4000)installed and put the board on a piece of cardboard with
There are 2 big problems (so far):
1. As soon as I plugthe power cord into the power supply, the Anti-Burn Regulator Alarm goes off. I have removed the jumper to disable it but it didn't make a difference still goes off.
2. When I power up, the ABR alarm stops, the fans all come on but there is no post. There are no beeps from the speaker and nothing is displayed on the monitor.
I have cleared the CMOS a number of times without success.
I'm assuming that my processor is fried. Maybe I zapped it during the installation process or it got fried when the other motherboard fried.
Any thoughts?
Thanks