Plexiglass

[Dante_Caligari]

I want to cut another hole in my side panel plexiglass cover,
but I have never done it before and I was wondering what the safest way to go about it would be.

 

[Juice Daddy]

when I needed to cut some plexiglass i use a dremel...

but it would get hot and the plexiglass would melt on to the bit...

I'd like to see peoples suggestions

~subscribeing~

 

[harry18]

never done it, but id say hole saw, provideing its a round hole that is...

 

[FghtinIrshNvrDi]

I'd use a fine toothed jigsaw. then, sand it down with some rough sandpaper, and clean it up with some 120 grit on the edges.

Ryan

 

[Dante_Caligari]

How do you start the cut?

 

[FghtinIrshNvrDi]

Take a drill and open up a spot to put your jigsaw in. Or you could just start on the side

Ryan