i am replacing the motherboard in a compaq presario 5102 with a ECS Elitegroup P4M800-M7.
the panel connector on the board has 9 pins for: hard drive LED +/-, power LED +/-, reset switch +/-, power switch +/-, and reserved.
the cable from the front panel was connected to the old board as follows: yel and blk cables to pins marked SP LED, red and wht to IDE LED, blu and org to RPW SW, and a single green to PWR LED.
what goes where?
the panel connector on the board has 9 pins for: hard drive LED +/-, power LED +/-, reset switch +/-, power switch +/-, and reserved.
the cable from the front panel was connected to the old board as follows: yel and blk cables to pins marked SP LED, red and wht to IDE LED, blu and org to RPW SW, and a single green to PWR LED.
what goes where?