Jayce
Fully Optimized
- Messages
- 3,056
- Location
- /home/jason
My buddy is building a computer, and ran into these two problems.
One: The monitor says no signal detected, however the graphics card is properly inserted and is hooked up properly. This graphics card is a 6600GT, and does not appear to have the 4 pin power connector to connect to the PSU, so I assume it does not need it.
Two: He's got two hard drives, both SATA interface by WD. When he starts up the computer, it automatically shuts down seconds later. If he unplugs the hard drive, it'll boot up (but again, the monitor doesn't work so he can't see sh*t). I was assuming that the BIOS disabled the SATA controller, could that be?
One: The monitor says no signal detected, however the graphics card is properly inserted and is hooked up properly. This graphics card is a 6600GT, and does not appear to have the 4 pin power connector to connect to the PSU, so I assume it does not need it.
Two: He's got two hard drives, both SATA interface by WD. When he starts up the computer, it automatically shuts down seconds later. If he unplugs the hard drive, it'll boot up (but again, the monitor doesn't work so he can't see sh*t). I was assuming that the BIOS disabled the SATA controller, could that be?