Hi everyone, I'm not exactly sure where to begin so I'll start off by explaining more or less what happens. I just got 2 SATA drives this week and I was able to successfully copy one of my drives but the other one has been giving me trouble. Whenever I connect the drive in a windows environment it detects it under device manager and the safely remove hardware icon shows up but it doesn't show up when I check local hard disk drives in my computer. When I bootup, the drive is detected so I doubt it has anything to do with the drivers, especially since it detects the other one just fine. I'm not sure if this has anything to do with mixing IDE and SATA drivers but I was hoping to simply copy everything over and give the IDE drives to my brother (he has 7.5 gigs total). Another thing I've also noticed is my system hanging when I have the successfully copied hard drive already connected but when I connect it in a windows environment it's detected and everything is fine. Help is greatly appreciated, thanks in advance!