sprtnbsblplya
Daemon Poster
- Messages
- 555
So I've always put my HD and optical on separate IDE channels in the past, but now I am building a Shuttle ST20G5 and it only has one IDE channel and the rest are SATA.
So my HD and my optical are both IDE so for now I am going to put them on the same channel until I save up enough to buy a SATA drive.
So, for this I just set the jumper on the HD to primary and the jumper on the optical to slave right? Just making sure as I've never configured like this before.
So my HD and my optical are both IDE so for now I am going to put them on the same channel until I save up enough to buy a SATA drive.
So, for this I just set the jumper on the HD to primary and the jumper on the optical to slave right? Just making sure as I've never configured like this before.