Hey, I have a MSI 845G Max. It has USB 1.1/2.0 ports all supplied via the motherboard. I do not have a USB PCI Card. My board has:
- 2 USB 1.1 ports soldered directly to the motherboard
- 2 USB 1.1 ports connected by one set of 9 pins (connected to case ports, called SET 1)
- 2 USB 2.0 ports connected by one set of 9 pins on a yellow connector (SET 2) AND one set of 9 pins on a black connector (SET 3)
One USB port needs 4 pins. Hence one set holds two ports with 1 pin left over.
----------------------------------------------------------------------
Seeing as how the yellow connector (SET 2) connected the USB 2.0 bracket, I assume it's USB 2.0 compatible. I bought a USB 2.0 internal card reader. I am more concerned with having it use USB 2.0. I want to connect it to SET 2 and move the USB bracket to SET 1 making it USB 1.1 compatible.
After all is done, I would have my USB 2.0 bracket on SET 1 and my card reader on SET 2. With just this change my case ports would be dead. My card reader uses 4 pins so I could hook up one case port to SET 2 and have it USB 2.0 so it could run my iPod at highspeed.
So my final install would have:
SET 1 - USB Bracket
SET 2 - Card Reader, one case port
SET 3 - USB Bracket
So my question is will this work? What does SET 3 do and why is my USB 2.0 bracket connected to both SET 2 and SET 3? I hope this isn't confusing and I'll pop in lots to answer questions. Please help.
- 2 USB 1.1 ports soldered directly to the motherboard
- 2 USB 1.1 ports connected by one set of 9 pins (connected to case ports, called SET 1)
- 2 USB 2.0 ports connected by one set of 9 pins on a yellow connector (SET 2) AND one set of 9 pins on a black connector (SET 3)
One USB port needs 4 pins. Hence one set holds two ports with 1 pin left over.
----------------------------------------------------------------------
Seeing as how the yellow connector (SET 2) connected the USB 2.0 bracket, I assume it's USB 2.0 compatible. I bought a USB 2.0 internal card reader. I am more concerned with having it use USB 2.0. I want to connect it to SET 2 and move the USB bracket to SET 1 making it USB 1.1 compatible.
After all is done, I would have my USB 2.0 bracket on SET 1 and my card reader on SET 2. With just this change my case ports would be dead. My card reader uses 4 pins so I could hook up one case port to SET 2 and have it USB 2.0 so it could run my iPod at highspeed.
So my final install would have:
SET 1 - USB Bracket
SET 2 - Card Reader, one case port
SET 3 - USB Bracket
So my question is will this work? What does SET 3 do and why is my USB 2.0 bracket connected to both SET 2 and SET 3? I hope this isn't confusing and I'll pop in lots to answer questions. Please help.