dennykyser
Baseband Member
- Messages
- 83
When my new build starts up, I can see the hard drive listed but windows goes to install after a few minutes it says windows did not detect a hard drive f3 to exit.
When I start the pc up, I do here one beep, that also indicates no master drive detected. however I do see the hdd listed when I start the pc Shows (Channel 0 Master WD 250 sata 1)
I see it listed as the pc starts, also dont see any response out of the floppy drive either. I have double checked all the conections.
The board is a ASUS, Hard Drive is a WD Sata 250.
any help would be greatly appreciated
When I start the pc up, I do here one beep, that also indicates no master drive detected. however I do see the hdd listed when I start the pc Shows (Channel 0 Master WD 250 sata 1)
I see it listed as the pc starts, also dont see any response out of the floppy drive either. I have double checked all the conections.
The board is a ASUS, Hard Drive is a WD Sata 250.
any help would be greatly appreciated