What the hell?!?!?!

Status
Not open for further replies.

frankiedacranki

Baseband Member
Messages
21
ok i just replaced my mobo,cpu, video card, and a powersupply....
and i was all ready to be reunited with my computer...
Then... all a sudden my monitor doesn't get a signal... :(
So i made sure i connected all the wires and stuff right and it was all in place....
Now i'm a virgin techie and all so can you techie gods help me what have i done wrong?
 
hmmm on the back of my psu its only 15 or 30

120V
15
K

those are usually what you want seen on the back of your psu
 
Hi There

Are you getting a beep signal? Is your vid card in tight.Is the new motherboard AGP slot or PCI-E slot.
 
the mobo is agp and my video card is agp as well both 8x
i haven't checked if the voltage of the powersupply. but it is 450w which i think is more than enough to supply power.
 
no...there is a red switch on the powersupply...it should read 115 and not 225... also is this an is the mobo for a Pentium or Amd?
 
did you wear an antistatic wrist band? or ground yourself when doing this work?

Also check to see if your panel connections are on the mobo correctly.
 
Status
Not open for further replies.
Back
Top Bottom