Case Holes for Water Cooling pipes

Status
Not open for further replies.

Harper

"I FEEL SO GOOD I FEEL SO NUMB, YEAH!!!"
Messages
6,947
Location
Australia
With Project : PZYCHO B!TCH II , I am planning to modding the case so that it's ready for water cooling when I go that far. I under stand that you need to have 2 holes for the pipes to go in and then out in the back of your case.

What sizes do these holes need to be? (In metric plz)
 
i think lol 1/2 tubing is like 13mm. Pretty much everyone uses 1/2 more then 3/4. So i guess its 13mm holes :D:p
 
With your case, you won't need to cut out any holes for external parts since you have a TON of room to work with. If you use parts from dangerden the whole thing should be internal and the only holes you'll need to drill will be to mount the pump and radiator
 
Status
Not open for further replies.
Back
Top Bottom