Building my first computer here and bought a Radeon ABIT X700 Pro to put on my ABIT AN8 SLI Guru Motherboard. Everything has gone just perfect except for my graphics card. It wont go in. The small chunk of bits on the side away from the center of the motherboard, I believe is the culpret. It would go all the way in (only like a millimeter off). When I clamp the other side down, it pulls the screw hole on the back pannel away from the back. This disaligns the screwhole off just a mil. or two so that I can not fit the screw in without flexing the motherboard. I'll see if I can get a pic of the situation up if this is too confusing.
What are people's ideas or suggestions? Should I get the card replaced, or is it normal for not perfect fit?
What are people's ideas or suggestions? Should I get the card replaced, or is it normal for not perfect fit?