Thermal probes

Status
Not open for further replies.

Joeisalsocool

Daemon Poster
Messages
519
Location
Syracuse, NY
Im going to put a thermal probe in my power supply, I'm just not sure how to attach it. Its going on one of the heatsinks inside. So I figured superglue would be perfect. How hot do you think superglue can get before it melts? I figure temps should be between 70 and 100F. Thanks.
-Joe
 
Seems kind of pointless to do to me :confused:

Don't know how much heat superglue can take, but I can say with probably 90% confidence that the heatsinks in the PSU probably get hotter than 100F
 
Superglue can hold up to 150F i think... shesh if it didnt hold at 100F and below i would have stuff falling down on me.....
 
Its not pointless, you'll know if your PSU fan dies.
Depending on the PSU, some have fan sensors. Besides that I don't think I've ever known of a case where a PSU fan failed before the PSU did
 
Status
Not open for further replies.
Back
Top Bottom