Well, I've put together my computer, but my motherboard seems to not want to use Dual Channel.
The motherboard is:
DFI "LANPARTY UT nF4 Ultra-D"
And the RAM is:
Corsair Value Select (Dual Pack) 512MBx2
Anyways, the problem is whenever I put it (the RAM) in the corresponding slots that should "enable" dual channel, the computer does not boot, or locks up at a certain point (I cannot check the point right now being at school). I sent Newegg an e-mail identifying the problem around a week ago and no response so far, I plan on writting again but I'm posting here as well to see if there is any "remedy" so to speak.
The RAM works fine in Single Channel (slots..1&2 I believe), it's just whenever I have it in dual channel or one stick in channel 3 (not sure if it's possible for it to boot this way, I don't think anything happened) or in slots 2&4 for Dual Channel that it doesn't work.
Any suggestions? Or is it just a fault motherboard?
Thanks.
The motherboard is:
DFI "LANPARTY UT nF4 Ultra-D"
And the RAM is:
Corsair Value Select (Dual Pack) 512MBx2
Anyways, the problem is whenever I put it (the RAM) in the corresponding slots that should "enable" dual channel, the computer does not boot, or locks up at a certain point (I cannot check the point right now being at school). I sent Newegg an e-mail identifying the problem around a week ago and no response so far, I plan on writting again but I'm posting here as well to see if there is any "remedy" so to speak.
The RAM works fine in Single Channel (slots..1&2 I believe), it's just whenever I have it in dual channel or one stick in channel 3 (not sure if it's possible for it to boot this way, I don't think anything happened) or in slots 2&4 for Dual Channel that it doesn't work.
Any suggestions? Or is it just a fault motherboard?
Thanks.