The setup.
MSI | NX6600GT
2 x 80GB|HITC SATA 8MB
CPU AMD 64 |3200+ ATHLON 939P 90 R
MB DFI|NF4 LANPARTY UT nF4 Ultra-D
DDR CRSR 512MB X2 KIT|VS1GBKIT400
Specification
Manufacturer: Corsair
Model: VS1GBKIT400
Speed: DDR400(PC3200)
Type: 184 Pin DDR SDRAM
Error Checking: Non-ECC
Registered/Unbuffered: Unbuffered
Cas Latency: 2.5
Support Voltage: 2.5V
Bandwidth: 3.2GB/s
Organization: two 64M x 64 -Bit
The Problem.
It's running in single mode and not dual mode.
It tells me the following on boot.
WARNING
The system is running in Single Channel Mode when you plug DIMM module in DIMM 1.
Please install 2 RAM modules into DIMM 2&4 for dual channel operation.
Now I took the ram out of slots 1 & 2 then put it in 2 & 4 but the system will not boot it just continously beeps very loudly. I searched on the forums and didn't really see anything pointing to my problem DIRECTLY so I'm posting a new thread. There FAQ on there webpage has nothing about it except to move a jumper on the board from set 1&2 to 2&3 to be able to up the voltage for massive overclocking (up to 4v's on the ram) and this isn't something I'm trying to do. I'm simply trying to run the system with Dual Memory and not Single Channel mode.
Can someone please tell me what's my problem or how to resolve this issue? The manual only has about 1 page on my issue and again it refers to simply upping the voltage and not this problem specifically.
MSI | NX6600GT
2 x 80GB|HITC SATA 8MB
CPU AMD 64 |3200+ ATHLON 939P 90 R
MB DFI|NF4 LANPARTY UT nF4 Ultra-D
DDR CRSR 512MB X2 KIT|VS1GBKIT400
Specification
Manufacturer: Corsair
Model: VS1GBKIT400
Speed: DDR400(PC3200)
Type: 184 Pin DDR SDRAM
Error Checking: Non-ECC
Registered/Unbuffered: Unbuffered
Cas Latency: 2.5
Support Voltage: 2.5V
Bandwidth: 3.2GB/s
Organization: two 64M x 64 -Bit
The Problem.
It's running in single mode and not dual mode.
It tells me the following on boot.
WARNING
The system is running in Single Channel Mode when you plug DIMM module in DIMM 1.
Please install 2 RAM modules into DIMM 2&4 for dual channel operation.
Now I took the ram out of slots 1 & 2 then put it in 2 & 4 but the system will not boot it just continously beeps very loudly. I searched on the forums and didn't really see anything pointing to my problem DIRECTLY so I'm posting a new thread. There FAQ on there webpage has nothing about it except to move a jumper on the board from set 1&2 to 2&3 to be able to up the voltage for massive overclocking (up to 4v's on the ram) and this isn't something I'm trying to do. I'm simply trying to run the system with Dual Memory and not Single Channel mode.
Can someone please tell me what's my problem or how to resolve this issue? The manual only has about 1 page on my issue and again it refers to simply upping the voltage and not this problem specifically.