eye-t 550watt power supply fuse size

Status
Not open for further replies.

cleato

Beta member
Messages
2
Hi folks got a new psu built it all up and bang the fuse went on the power supply,its a little glass one ,do you know what size i should replace it with..here is the spec..thanks
Product Feature / Commentary:
*
4 Pin + 12V Power Connector for Pentium4
2 BLUE LED LIGHT-UP FANS fAN SPEED CONTROLER *
Power Factor Correction [Passive-PFC] > 0.78 *
Thermal Control Function *
Complies with CISPR22 230 VAC Operation *
Meets EN60950 Requirements *
Over Voltage / Over Power / Short Circuit Protection *
100% Hi-pot & Function (Chroma) Tested *
100% Burn-in Under High Ambient Temperature (50°C) *
MTBF Over 100,000 Hrs. at 25°C *
Temperature Range:
10~50 °C Operating, -40~70 °C Non-Operating
Hold-up Time:
< 16.6 ms at Full Load & Normal Input Voltage
Dielectric Protection 1800 VAC for 1 sec
Humidity:
5~95% RH
Efficiency:
68% min, 72% typical @ Full Load
Power Good Signal:
On Delay 100~500 ms, Off Delay 1 ms
Overload Protection:
100~150% Load
Over Voltage Protection:
+5 V max 7 V, +12 V max 15.6 V, +3.3 V max 4.5 V
Inrush Current:
80A (RMS) max for 230 VAC
Remote Sensing: +3.3 V
Cooling Fans:
8 cm DC Fan............
 
ooops

Forgot to say the fuse is in pieces and says 8amp on the power supply board dont know if that is relevant..........thanks
 
Status
Not open for further replies.
Back
Top Bottom