rememberme
In Runtime
- Messages
- 184
Ok I am in a boo boo situation...
I have tried to install XP on my new rig using a recovery CD - which didn't worked because it is missing a file that is required to complete setup... Anyway, I don't wanna go out and buy the full version, so I am going to revert back to WIN 95 for a few weeks (there is a reason for this).
But everytime I boot up it starts to load XP setup (the bit where u shud go on to select language and IP settings etc). This then gives me an error... "missing file blah blah" then reboots. This is an endless cycle.
I put the 95 CD in and try to boot from that, but when it reads from CD it goes straight onto the hard drive again and into XP setup. This means i can't seem to run 95 setup because of the XP bad installation.
Is there a boot disk I can make to run the 95 setup? Or maybe get into DOS so I can tell it to run setup on the CD???
I have tried to install XP on my new rig using a recovery CD - which didn't worked because it is missing a file that is required to complete setup... Anyway, I don't wanna go out and buy the full version, so I am going to revert back to WIN 95 for a few weeks (there is a reason for this).
But everytime I boot up it starts to load XP setup (the bit where u shud go on to select language and IP settings etc). This then gives me an error... "missing file blah blah" then reboots. This is an endless cycle.
I put the 95 CD in and try to boot from that, but when it reads from CD it goes straight onto the hard drive again and into XP setup. This means i can't seem to run 95 setup because of the XP bad installation.
Is there a boot disk I can make to run the 95 setup? Or maybe get into DOS so I can tell it to run setup on the CD???