BootMagic 8.0

[dansyd19]

I installed two hard disks in my computer and D1 (primary master) uses WXPH and D2 (primary slave) uses W2KP. Then I install BootMagic 8.0 to boot into these two disks. However, I can only boot into D1. I look at bootmatic configuration and note that D1 is in disk 1, Pri-1 and D2 is in disk 2, Pri-1. when I look at the visible partition, however, I see that D2 is using disk 1 (instead of disk 2). I change it to disk2 and click OK and save. But when I come back to look at the visible partition, it reverts to disk 1. And of course, I cannot boot into D2. Can anyone help? (I have also enabled "Advance Partition Hiding" options tab).
Thanks.

 

[suker]

you must do a bridle wire in your primary HD and slave HD!

in the light of the directions on you HD

like this:

 

[dansyd19]

Thanks Sucker. But what do you mean by bridle wire? Do you mean the jumper setting? My D1 is set as Primary master and my D2 is set as Primary slave. Awaiting your advice. Thanks.

 

[Harper]

you must do a bridle wire in your primary HD and slave HD!

What do you mean by "a Bridle Wire"?
It the first time where I have ever heard that phrase.

The only idea that I have for it is connecting 2 hard drives on the same channel.

Or is it some thing else?

 

[EricB]

use pm8 to set the hidden partition to active from windows

somehow your configuration with bootmagic is messed up

try uninstalling and reinstalling bootmagic

give us more detail like the exact steps you took in installing everything