I nEED Help

Status
Not open for further replies.

TekNina

Beta member
Messages
3
i just bought my P4 2.8, 1GB pc3200 ram, mobo, and geforce FX 5600 XT.....and when i went to put windows on, i booted up, overclocked it, with sufficient cooling to 2.97, and then proceeded to install windows....i then get a message...a blue screen, and en error saying to removie any new hardware i might have.....i restart the machine, only to get some lettering in gibberish....which i cannot read. Itll boot up then stop, boot up with the lettering then freeze in bios (screen that is not the comp)...

ANY SUGGESTIONS WELCOMED

Trevor
 
I bet u must be keeping squeezed oranges outside to capture dew and re-squeeze them in morning to get the last bit of the diluted juice left.

wasnt it working good that u overclocked it?
 
yes...it was working good, then i overclocked it, then it was working and all of a sudden i got the error to remove any newly installed hardware i have.......ne ideas??
 
make sure your PCI BUS speed is locked 33 . It will rise with the CPU bus speed if its set to auto wich of course is a bad thing.
Reset defaults and start over .
 
Status
Not open for further replies.
Back
Top Bottom