earwicker7
In Runtime
- Messages
- 345
I've just installed a loop on my computer and I'm trying to jumpstart it so that I can leak test. I have done this before, but it flat out is not working this time. I took a piece of an old keyring (the ones they give you at car rental places, so it's not the hard ones) and placed one end in the green part of the 24 pin connector, and one in a black connector (I tried about five of them). I have it plugged in, and I hit the power button, and... nothing. After trying this a bunch of times and looking to see if I'd knocked any cables loose (I hadn't) I decided to plug the connector back into the PSU just to see if my computer would start up; it did, and I yanked the cord immediately so that there wasn't enough time for the water to get in the loop.
Can anyone think of what is causing this? What am I supposed to do to test my loop for leaks if this won't work?
Thanks!
Can anyone think of what is causing this? What am I supposed to do to test my loop for leaks if this won't work?
Thanks!