MindoverMaster
Golden Master
- Messages
- 12,213
- Location
- /home
I was going to put my WD Black 1.5TB into my computer, as for some odd reason, it doesn't share it over the network in my server. *shrugs*
So I put it in, had to connect from the other side, being a HAF. and I had to reposition the bay, and I do so, look at back, the SATA connecter is busted off the drive. Like, WTF?! So I try to connect the bare wires to the connector, no dice.
The question, therein, would WD just change the PCB board? Keeping the data intact? I have a lot of movies on there that I just copied from DVD. Would take awhile to back those up all again. I'll be sure to contact WD, but just from your experience. As I'll be busy this weekend, it'll have to wait.
RMA time....
So I put it in, had to connect from the other side, being a HAF. and I had to reposition the bay, and I do so, look at back, the SATA connecter is busted off the drive. Like, WTF?! So I try to connect the bare wires to the connector, no dice.
The question, therein, would WD just change the PCB board? Keeping the data intact? I have a lot of movies on there that I just copied from DVD. Would take awhile to back those up all again. I'll be sure to contact WD, but just from your experience. As I'll be busy this weekend, it'll have to wait.
RMA time....