aeroplane22
Baseband Member
- Messages
- 81
- Location
- Southern Maine
Hello all, have a little problem with a Tri-LCD stand.
I got a Triple-LCD stand (horizontal), and I made the mistake of assuming the left-and-right mounts would angle in the monitors flush with center, so I could view with peripheral or a turn of the head. Instead, it's just flat horizontal, or the two on the side get pushed back 5-inches.
So basically, the 2-LCDs are 5-inches away from flush with the center screen.
This is what I got: Triple/Three LCD Monitor Stand Free Standing up to 26"
You can see what I mean here, how they are not flush, and need an adapter of some sort to extend the side screens about 5-inches:
----------------------------------------------------------------------------------
----------------------------------------------------------------------------------
Any ideas? If I could, I'd weld/solder something on, but I'm not capable. I'm just looking to do this in the most cost-effective, juryrig way.
I'm thinking some kind of backplate, like a box/brace, that can fasten 5-6 inch screws into the original holes. Does anything like this exist?
I got a Triple-LCD stand (horizontal), and I made the mistake of assuming the left-and-right mounts would angle in the monitors flush with center, so I could view with peripheral or a turn of the head. Instead, it's just flat horizontal, or the two on the side get pushed back 5-inches.
So basically, the 2-LCDs are 5-inches away from flush with the center screen.
This is what I got: Triple/Three LCD Monitor Stand Free Standing up to 26"
You can see what I mean here, how they are not flush, and need an adapter of some sort to extend the side screens about 5-inches:
----------------------------------------------------------------------------------
----------------------------------------------------------------------------------
Any ideas? If I could, I'd weld/solder something on, but I'm not capable. I'm just looking to do this in the most cost-effective, juryrig way.
I'm thinking some kind of backplate, like a box/brace, that can fasten 5-6 inch screws into the original holes. Does anything like this exist?