Startup problem with new build

Status
Not open for further replies.

leonardmp92

Daemon Poster
Messages
602
Hello,

Just built the below machine. By hitting the power button, I cant get it to start up. I usually have to hit the button below it (maybe the "reset" button), before I get a post "beep", then it goes into the startup. It shuts down OK though. Maybe I wired the startup/reset buttons wrong on the mobo?

Thanks.
 
Does the Power button shut it down? It sounds like you just switched the Reset Switch and the Power Switch. Open up the case and check or just boot the machine up and hit the power switch, if it resets you know you mixed them up.
 
It doesnt reset when I hit the power switch. Sometimes the reset switch does work. This thing is acting really buggy, just now it went thru the normal BIOS startup, then froze. Not sure the problem. I've been able to get it to fully load before though.
 
Status
Not open for further replies.
Back
Top Bottom