Finally splitting my loops.

[Slaymate]

Have you hooked up that mosfet block yet?

 

[Burn]

Nope not yet... Soon though... I've been pretty busy with school and re-doing the siding of our rental house.

Maybe today I'll tear everything down.

 

[Burn]

I feel like an idiot... I thought the extra 3' strip of tubing I had would be enough, but turns out even with my small extra pieces I was about 2' short... So I have it all in one loop right now, I'll be ordering more stuff sometime in the next week.

@Slaymate: what temps were you getting with this mosfet block? I think I may have seated it wrong or something, I'm still getting like high 60's load And that's with 1.35 VTT and 800hz for pwm frequency...

 

[Slaymate]

Under load my temps were in the HI 50's to Lo 60's, but it was the only block in the loop.

 

[Burn]

I reseated and put some new mx-2 between the block and heatplate.. Temps dropped by quite a bit. Haven't seen it past 60 load yet Hopefully it'll stay that way...