Just to humor the 2 of you, I measured the screw hole spacing on my 230x200 fan and i got about 6.1" and thanks to Burninator's link I now know that 6.1" is 154.94mm (we'll say 155mm). Now anybody with a 200x200mm fan want to measure the hole spacing so that i know if it is the same or not?
Labeled:
Being that I shipped most of my case off to my brother to sandblast, this is what I have left to sand. The top and bottom panels are taped up to prevent any damage to factory paint. Working on the side panels now.
I removed the side window.
First tape applied (going in a bottom up fashion so that i can get the flat line of the tape to line up with the slit opening to prevent any overspray when I get there)