Techist - Tech Forum - View Single Post - First build...help!

Click Here to Login
View Single Post
Old 08-21-2009, 12:50 AM   #12 (permalink)
TaBryan09
Junior Techie
 
TaBryan09's Avatar
 
Join Date: Aug 2009
Location: Massillon Ohio
Posts: 63
Default Re: First build...help!

Newegg is realy good about returning products

Now for some Hardcore Troubleshooting

Pull one by one every cable, card, and front panel stuff off the board, (EXCEPT POWER SWITCH!) if your pulling and you go to check it and you get NOTHING at all then make sure you didn't pull your power switch off lol been there done that, also make sure you plug the power in everytime too, i hate stating the obvious but SH** HAPPENS lol, check it each pull until you are down to the CPU RAM and Vid

If nothing still i would pull your vid and slap in a cheapo PCI vid card and see if you get anything

also I would reset the CMOS, pop out the battery and unplug the power supply then press the power button for about 15secs then reinsert the battery and also check the mobo manual for the CMOS jumper settings and make sure it is set right

and if still nothing im going to have to say its a CPU issue, (worst case scenario!)

good luck
__________________
TaBryan09 is offline  
 


Copyright 2002- Social Knowledge, LLC All Rights Reserved.

All times are GMT -5. The time now is 01:01 PM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2018, vBulletin Solutions, Inc.