T-line placement

[Burn]

I'm redoing my loop pretty soon (have the gpu block, just need the 4890), and wanted to make sure my new t-line placement was ok. the reason i ask is because i read something that said t-lines should be placed right before the pump intake but was wondering if this would work

this is where i would like to move it:

 

[Apokalipse]

doesn't matter, as long as you can fill it up.

What I usually do is have one tube not connected (and the case oriented so that the open ends are upwards), and fill the loop until it's mostly full. Then connect the tube, power the pump from another PC just to get the air to the T-line, and fill it up from there.

 

[Burn]

thanks. my 4890 should be here tomorrow, i'll post up some pics of the loop when im done re-doing it