casemod galaga

Status
Not open for further replies.

taintedplay

lolwut?
Messages
1,140
This case is based on the old 2d galaga arcade game, but will be 3d obviously. its made of 1.5inch square blocks.

inspiration:
galagaship.jpg

3d-pixel-illustratie-voxel-illustration_namco-galaga-8-bit-game.jpg


as you can see, the blocks are not even lol. i have a belt sander im going to use to clean it up.
Picture001-7.jpg

Picture002-8.jpg

Picture007-2.jpg

Picture012-2.jpg


Picture013-2.jpg

Picture014-2.jpg

Picture015-2.jpg

Picture016-2.jpg
 
Picture017-2.jpg
Picture018-2.jpg
Picture020-2.jpg

Picture023-1.jpg

Picture024-1.jpg

Picture025-1.jpg
Picture026-1.jpg




im almost done with building the whole thing, gotta sand down some of the midmatched blocks, primer and paint it
 
well im only sanding the edges so its not very much off. i built it out of blocks so that theyre not lined up, so you can get the 8bit feel. ill only sand the blocks that are way to big and disrupt the general lines
 
That's bigger than I thought it would be too, that had to be a LOT of work. Looks pretty cool though, are you going to paint it the same colors as that image?
 
yup will be painted the same colors as the image. for the model, 4 blocks on mine equals one block on the image
 
whoa, i thought you were modding a case. not building one. make sure it has good cooling or else it might catch on fire :eek:

nice job
 
Status
Not open for further replies.
Back
Top Bottom