ok, with the sale of my current rig pending, i went out and picked up another antec 300 in advance so i can have it ready for a new build later next week.
what i have so far:
antec 300 case
primer
flat black paint (for interior)
10x12 plexy
18x12 plexy (would need to cut this down a lil)
i would like suggestions that arnt too difficult to do with a dremel for the side window cutout.
the side panel is aprox 17x17 so i have enough plexy glass to do both sides if i really wanted, but no need for the right hand side.
i also need some trim (u channel), i should probably just go over to mnpctech.com and get some of theirs U-channel edge molding for PC Mod Window, as my last antec 300 side window i used some crap from autozone and it was kinda thick for my tastes. but if you know of a better place, please advise!
any other ideas, shoot them here! im up for anything that isnt too difficult.
just incase you dont know what the antec 300 looks like
here is my first antec300 window job to compair with (8x10 window cutout)
thanks for all comments and or ideas guys, i want to put more time into this project than i did my last.
edit: here is a cutout idea for the window, it should not be too hard.
what i have so far:
antec 300 case
primer
flat black paint (for interior)
10x12 plexy
18x12 plexy (would need to cut this down a lil)
i would like suggestions that arnt too difficult to do with a dremel for the side window cutout.
the side panel is aprox 17x17 so i have enough plexy glass to do both sides if i really wanted, but no need for the right hand side.
i also need some trim (u channel), i should probably just go over to mnpctech.com and get some of theirs U-channel edge molding for PC Mod Window, as my last antec 300 side window i used some crap from autozone and it was kinda thick for my tastes. but if you know of a better place, please advise!
any other ideas, shoot them here! im up for anything that isnt too difficult.
just incase you dont know what the antec 300 looks like
here is my first antec300 window job to compair with (8x10 window cutout)
thanks for all comments and or ideas guys, i want to put more time into this project than i did my last.
edit: here is a cutout idea for the window, it should not be too hard.