Rate the Wire Management Above You!

100_1999.jpg

that's not dust it's the suns reflection :speechless:
100_2000.jpg

top is open mesh,but your right....
arrows on Zalmans installation site/manual
:embaressed: temps low 30's
 
Turn your HS around 90 degrees to the right.

I am it's really not that hard to see the Blue and Red arrows on Zalmans installation site/manual...

*sigh*
 
maybe a 5/10...

Though to be honest, most of my problems with it are not your fault. The poor 24 pin location, and bottom mounted psu both make it hard to clean up.
 
maybe a 5/10...

Though to be honest, most of my problems with it are not your fault. The poor 24 pin location, and bottom mounted psu both make it hard to clean up.

Correct. The 24-Pin Positioning is poor, and Obviously with the PSU Mount at the bottom, there isn't a lot i can do. Its sufficient Enough to keep all temps Below 30 Degrees C.

Good enough if you ask me.

Have you posted your rig? I haven't really looked thourough , just flicked through the thread.. :)
 
Back
Top Bottom