ricanflow
Golden Master
- Messages
- 6,317
- Location
- Euless, Tx
Antec Skeleton
- Thread starter RogueSeven
- Start date
- Status
NosBoost300
I poop on the rug
- Messages
- 10,220
- Location
- Bellflower, CA
when are they gonna change the names of those things to gt series!
NosBoost300
I poop on the rug
- Messages
- 10,220
- Location
- Bellflower, CA
3 weeks old and only stress tested once 
not a chance its scrambled!
not a chance its scrambled!
NosBoost300
I poop on the rug
- Messages
- 10,220
- Location
- Bellflower, CA
wow crazinesss!!!! lol maybe some day we'll meet
its a small small world.. i met a member here once.. forgot his name though, bought an 8800gt from him... then sold it 2 weeks later.. haha
its a small small world.. i met a member here once.. forgot his name though, bought an 8800gt from him... then sold it 2 weeks later.. haha
saltynay
Patron
- Messages
- 5,149
- Location
- West Coast, Singapore
If you haven't bought it yet there is a quite good mini review on the bottom(and next page) of this forum thread.
Antec Skeleton - Kustom PC's Forums
Antec Skeleton - Kustom PC's Forums
BongWizard
Electical Engineer
- Messages
- 916
- Location
- OZ
just gotta say... i wouldnt buy an exposed case when you can build one yourself... i've got an old plexi, screw and washer (yet still super awesome) 2 shelf bench i just dug out so i could frankenstein together a rig to do some tests on this P4 i just found... and its so much cooler cuz you can customise the bench with little addons specifically for your hardware... and its all dope and homemade and junk... ghetto but soo soo good!
saltynay
Patron
- Messages
- 5,149
- Location
- West Coast, Singapore
Yeah but the Antec skeleton actually has a "wow" factor whilst your homebrew one sounds as if it has a "wtf" factor.
aspire
The Water Cooling Guru
- Messages
- 5,308
- Location
- United States
Sure,
If you get off on Silver plastic and huge low cfm fans.
After looking at the mini review, it seems like everything I thought would go wrong did.
The mounts for the CD drives look like arse.
Any heatsink bigger than a Freezer 7 will not fit.
It's almost entirely plastic.
Wire management is impossible.
And it cost's a fortune.
ricanflow
Golden Master
- Messages
- 6,317
- Location
- Euless, Tx
It could be a decent case with:
1. less plastic
2. more height for large heatsinks (TRUE, TT..etc..)
3. cheaper price
I think the cfm on the fans is fine...since its open air.
1. less plastic
2. more height for large heatsinks (TRUE, TT..etc..)
3. cheaper price
I think the cfm on the fans is fine...since its open air.
- Status
Similar threads
