C0RR0SIVE
Golden Master
- Messages
- 9,213
- Location
- Lexington, KY
Ok, so I have four AM2 processors, one is a 4400+, one is a 3000+ and two are 6000+ processors, I can take each processor to 3.0Ghz EASILY, now with a big jump in voltage I can hit 3.3Ghz, the 6000+ is already at that 3.0Ghz, can't even raise it 1Mhz unless I apply roughly the same amount of voltage to it that I end up putting to my other processors, then I can take it to around 3.3Ghz prime stable, but ANY higher than that and the PC literaly locks up during POST, so could it be my motherboard holding me back??? Or is that just as far as I can humanly go, temps never get above 25C at full load with my water cooling system now...
BTW this is a K9n Platinum, and they have issues with the OVP circuit, and here recently it has had issues with the Hyper Transport bus, the mobo complains about some sort of threshold being exceeded at random times during restarts...
BTW this is a K9n Platinum, and they have issues with the OVP circuit, and here recently it has had issues with the Hyper Transport bus, the mobo complains about some sort of threshold being exceeded at random times during restarts...