Hey, I just got my build together q6600, lanparty dk x38, 4gb patriot ram, hd4850, and corsair 750tx. So it's all together and it runs fine for a little bit, but then it freezes. When I do a hard restart and go into the bios it says my motherboard temp is 90C. That's really high and I don't know why it's that high. Did I mess up the wiring or something? cpuz and bios screenshots will be posted within a couple mins.
MB too hot.
- Thread starter digg98
- Start date
- Status
wafflehammer
Fully Optimized
- Messages
- 2,502
- Location
- Logan, WV
did you attach the northbridge heatsink? and if so, did you seat it properly with thermal compound?
wafflehammer
Fully Optimized
- Messages
- 2,502
- Location
- Logan, WV
yea most NB's do run hot and that's a good idle temp for GPU
aspire
The Water Cooling Guru
- Messages
- 5,308
- Location
- United States
You seriously, forgot to put a heatsink on the northbridge?...
Kids these days...
Kids these days...
toxicity_27
The Angriest of Amoebas
- Messages
- 1,255
- Location
- Minnesota
Haha, my mobo came with it on already.. They change that recently?
thirdshiftdj
I feel funny...
- Messages
- 3,808
- Location
- Lowell,Ma
DFI comes w/ NB off to allow to you apply good TIM and heatsink
MetalOwns
In Runtime
- Messages
- 432
- Location
- Franklin, WI
My DFI board came with it on.
- Status
