Twizted_3kgt
Daemon Poster
- Messages
- 771
- Location
- NY, USA
I need some advice from those of you who have gone above 3.3ghz. I seem to be stuck here. I can boot up with 3.6ghz and start to run Prime95 with it, but it will get errors within the first 30 seconds. And this is with the voltage around 1.46v! Anything lower and its just more and more unstable to the point that it doesn't boot.
What kind of voltages are you 3.6ghzers running? And what is the VID of your cpu? What could be holding me back?
I haven't been successful in overclocking my RAM at all, I have it set to "Unlinked" so it stays right at 800mhz no matter the FSB.
What kind of voltages are you 3.6ghzers running? And what is the VID of your cpu? What could be holding me back?
I haven't been successful in overclocking my RAM at all, I have it set to "Unlinked" so it stays right at 800mhz no matter the FSB.