my computer was working just fine until i decided to put a 2.8 OC on it with 1:1 fsb/ram ratio. i set cas latency to 5 and all other ram stuff on auto.
voltage was at 1.4, pci speed(forgot what its called) was 105, default 100
the post screen came up and said press delete to go to setup
this didn't work i pressed delete many times
so i rebooted into bios and set it back at default cpu core Voltage and core clock and pci speed
i left the ram latency at 5 cuz i forgot about it
save and exited
rebooted and the computer doesn't do the power check thing at the beginning!
(where it turns on then turns off then turns on and windows loads)
monitor is recieving no signal at all!!
dvi cable is firmly in place
pci-e power cord and 8800gt is in place as well
is this an overclocking screwup or something else?
voltage was at 1.4, pci speed(forgot what its called) was 105, default 100
the post screen came up and said press delete to go to setup
this didn't work i pressed delete many times
so i rebooted into bios and set it back at default cpu core Voltage and core clock and pci speed
i left the ram latency at 5 cuz i forgot about it
save and exited
rebooted and the computer doesn't do the power check thing at the beginning!
(where it turns on then turns off then turns on and windows loads)
monitor is recieving no signal at all!!
dvi cable is firmly in place
pci-e power cord and 8800gt is in place as well
is this an overclocking screwup or something else?